Publisher： Maney Publishing
ISSN： 1743-2898
Source： Plastics, Rubber and Composites, Vol.33, Iss.8, 2004-10, pp. : 330-334
Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.
Abstract
Related content
Mould fouling of elastomers during injection moulding
By Hornsby P. R. Singh I. Daley J. R. Firth J.
Plastics, Rubber and Composites, Vol. 35, Iss. 8, 2006-10 ,pp. :
Access to resources
Recommend
Evaluation of heat management in injection mould tools
By McCalla B. A. Allan P. S. Hornsby P. R.
Plastics, Rubber and Composites, Vol. 36, Iss. 1, 2007-02 ,pp. :
MEMS microvalves to optimise reactant flows
Fuel Cells Bulletin, Vol. 2002, Iss. 11, 2002-11 ,pp. :
Focus on Powder Coatings, Vol. 2002, Iss. 8, 2002-08 ,pp. :