Chapter
Microstructures of Rapidly Solidified Cu-Hf Alloys
Microgravity Solidification of Immiscible Alloys
Eutectic Growth and the Influence of Gravity
Chill Casting of Al-Pb- and Al-Bi-Alloys in Aerogel Crucibles during a Parabolic Flight
Liquid Metal Processing Using the Drop Tower at ZARM, Bremen, Germany
Polyurethane Foams Formed in a Microgravity Environment
Influence of Gravitation on Growth Rate and Quality of Aqueous Soluble Crystals
Diffusion in Liquid Pb-Au Binary System
Paratellurite Single Crystal Growth at Low Gradient Conditions
The Numerical Modelling of Microsegregation in Alloy Steel Systems
Morphology and Segregation Behaviour in Directionally Solidified Copper-Manganese Alloys with Compositions near the Melting Point Minimum
Calculation of Phase Diagram and Solidification Paths of Ternary Alloys: Al-Mg-Cu
The Effect of Temperature Gradient Zone Melting on Solute Profile during Solidification of 0.8 % C Steel
Experimental Study and Simulation of Solidification in Composite-Added Microalloyed Steel Ingots
Crystal Growth Simulation: From Fractals to Compact Growth
Calculation of Dendrite Tip Temperature during Constrained Growth
The Isothermal Dendritic Growth Experiment
Simulation of Side Branch Development in Thermal Dendritic Grains
Instability of Coarse Microstructures during Equiaxed Growth
Dendritic Growth in Undercooled Melt with Forced Convection
Directional Solidification of Succinonitrile within the Porous Network of an Aerogel
Microstructural Evolution during Directional Solidification of Superalloy CMSX-6
Three Dimensional Observation of Directional Solidification Front by Forced Decanting
Experimental Study of the Development of Sidearms in Dendrites
An Influence of the Mg Content on the Structural Composition of the Al-Zn-Cu-Mg Alloys
Evolution of the Microstructure during Solidification of Immiscible Alloys
Numerical Modelling of Microstructure Evolution in Castings of Immiscible Alloys
New Insight on the Solidification of Al-In Monotectic Alloy
Experimental Results to the Displacement of Droplets by the Solidification Front in Near Monotectic Alloys
The Effect of Convective Instability on Coupled Growth of Hypermonotectic Alloys
Directional Solidification of Al-Al3Ni Eutectic Alloys in an Aerogel Furnace
Viscosity Investigations in Eutectics
Thermodynamics of Irregular Eutectic Growth
Influence of Control and Material Parameters on Regular Eutectic Growth and Interlamellar Spacing Selection
Interlamellar Spacing in Al-Si Eutectic Growth Controlled by Temperature Gradient
Gravity Influenced Convection in Al-Ni Melt
Influence of Release and Transport of Latent Heat on Solidification Behavior in Faceted Crystal
Single Crystal Growth Mechanism of YBCO Superconductive Oxide
Evidence for a Coupled Growth of the Properitectic α-Ti and the Peritectic γ-TiAl in Binary Titanium Aluminides
The Effects of Vertical Magnetic Fields on Segregation in HgCdTe
Permeabilities for Interdendritic Melt Flow through Equiaxed Aluminium Castings
Deformation Behavior during Solidification of Steels and Aluminium Alloys
Formation of the Sulfide Inclusions during the Solidification of Cast Fe-Mn-C-S Alloys
Displacement on the Surface Mould and Metal during the Solidification of Nodular Graphite Iron Castings
Relation between the Volume Change during the Solidification of Lamellar and Ductile Cast Iron and the Crystallization Sequence
Experimental Determination of the Influence of Casting Conditions on the Solidifaction of Zinc Die Castings
Numerical Simulation of the Solidification of Zinc Die Castings
Experimental Study into the Mechanism of Formation of Cone of Crystals in a Steel Ingot
A REM Tracer Study into Mechanism and Kinetics of Steel Ingot Solidification
Solidification of In-Situ Aluminium Composites
Kinetic Diffusional Model of Transient Growth of Multi-Layer Nodular Grains
Diffuse Interface Approach to Crystal Nucleation
Interfacial Phenomena during Melt Processing of Ceramic Particle-Reinforced Metal Matrix Composites Part I. Introduction (Incorporation) of Solid Particles into Melts
Interfacial Phenomena during Melt Processing of Ceramic Particle-Reinforced Metal Matrix Composites Part II. Interfacial Force between a Spherical Particle and an Approaching Solid/Liquid Interface
Method for Estimating Solid-Solid Interface Energies in Metal-Ceramic Systems: The Aluminium - Silicon Carbide System
Development of Gas-Solid Structures at Various Orientations of the Solidification Front with Respect to the Earth Gravity Field
Nonequilibrium Crystal Growth and Kinetic Roughening in Greatly Undercooled Ge and Ge-2at%Sn
The Dynamic Tests of the UMC Capsule
The Prediction of the Microstructure of Cast Iron Using Thermal Analysis
Temperature Distribution of Transient Crystallizer
On the Transition of Solidification Mechanisms in Highly Undercooled Germanium
Solidification and Gravity II
Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.
