Development and Research of the Method of Severe Alternating Deformation in the Process of Rolling of Thick Steel Sheets and Plates Made of Non-Ferrous Alloys

Publisher： Trans Tech Publications

E-ISSN： 1662-9779|2018|284|265-269

ISSN： 1012-0394

Source： Solid State Phenomena, Vol.2018, Iss.284, 2018-11, pp. : 265-269

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

The Influence of Severe Plastic Deformation Process on Structure and Properties of AZ 31 Alloy after Selected Heat Treatment

By  

Solid State Phenomena, Vol. 2018, Iss. 275, 2018-08 ,pp. : 134-146

Trans Tech Publications

Access to resources Recommend Favorite

Instability of Plastic Deformation in Low-Alloy Copper Alloys

By  

Solid State Phenomena, Vol. 2018, Iss. 275, 2018-08 ,pp. : 113-123

Trans Tech Publications

Access to resources Recommend Favorite

Computer Simulation of Plastic Deformation in Tial Alloys in the Presence of Chromium

By  

Defect and Diffusion Forum, Vol. 2018, Iss. 386, 2018-11 ,pp. : 383-387

Trans Tech Publications

Access to resources Recommend Favorite

Features of Steel Tape Deformation-Strength Properties Formation by Plasma-Cavitating Treatment

By  

Solid State Phenomena, Vol. 2018, Iss. 284, 2018-11 ,pp. : 1291-1296

Trans Tech Publications

Access to resources Recommend Favorite

Case Study: Engine Bracket Made by Rheocasting Using the SEED Process

By  

Solid State Phenomena, Vol. 2019, Iss. 285, 2019-02 ,pp. : 441-445

Trans Tech Publications

Access to resources Recommend Favorite