Material Removal Rate Control in Open-Air Type Plasma Chemical Vaporization Machining by Pulse Width Modulation of Applied Power

Publisher： Trans Tech Publications

E-ISSN： 1662-9795|2014|625|593-596

ISSN： 1013-9826

Source： Key Engineering Materials, Vol.2014, Iss.625, 2014-10, pp. : 593-596

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Basic Study on Etching Selectivity of Plasma Chemical Vaporization Machining by Introducing Crystallographic Damage into Work Surface

By  

Key Engineering Materials, Vol. 2014, Iss. 625, 2014-10 ,pp. : 550-553

Trans Tech Publications

Access to resources Recommend Favorite

Material Removal Rate, Kerf, and Surface Roughness of Tungsten Carbide Machined with Wire Electrical Discharge Machining

By Shah Aqueel   Mufti Nadeem   Rakwal Dinesh   Bamberg Eberhard  

Journal of Materials Engineering and Performance, Vol. 20, Iss. 1, 2011-02 ,pp. : 71-76

Springer Publishing Company

Access to resources Recommend Favorite

Analysis of Effects of Cutting Parameters of Wire Electrical Discharge Machining on Material Removal Rate and Surface Integrity

By  

IOP Conference Series: Materials Science and Engineering, Vol. 115, Iss. 1, 2016-02 ,pp. : 120-126

IOP Publishing

Access to resources Recommend Favorite

Heat-Assisted Machining for Material Removal Improvement

By  

IOP Conference Series: Materials Science and Engineering, Vol. 88, Iss. 1, 2015-09 ,pp. : 377-381

IOP Publishing

Access to resources Recommend Favorite

Comparative study of SVPWM (space vector pulse width modulation) & SPWM (sinusoidal pulse width modulation) based three phase voltage source inverters for variable speed drive

By  

IOP Conference Series: Materials Science and Engineering, Vol. 51, Iss. 1, 2013-12 ,pp. : 194-201

IOP Publishing

Access to resources Recommend Favorite