The effect of substrate surface preparation on the wear and failure modes of TiN coated high speed steel circular saw blades

By Lewis D.B.   Bradbury S.R.   Sarwar M.  

Wear, Vol. 197, Iss. 1, 1996-09 ,pp. : 82-88

Elsevier

Access to resources Recommend Favorite

Failure mechanisms of a whisker-reinforced ceramic tool when machining nickel-based alloys

By Jun Z.   Jianxin D.   Jianhua Z.   Xing A.  

Wear, Vol. 208, Iss. 1, 1997-07 ,pp. : 220-225

Elsevier

Access to resources Recommend Favorite

Ceramic materials wear mechanisms when cutting nickel-based alloys

By Lo Casto S.   Lo Valvo E.   Lucchini E.   Maschio S.   Piacentini M.   Ruisi V.F.  

Wear, Vol. 225, Iss. 1, 1999-04 ,pp. : 227-233

Elsevier

Access to resources Recommend Favorite

The Effect of Cutting Speed and Feed Rate on Surface Roughness and Tool Wear when Machining Machining D2 Steel

By  

Materials Science Forum, Vol. 2017, Iss. 909, 2017-12 ,pp. : 80-85

Trans Tech Publications

Access to resources Recommend Favorite

A study of the wear mechanisms of Ti 1-x Al x N and Ti 1-x-y Al x Cr y N coated high-speed steel twist drills under dry machining conditions

By Harris S.G.   Doyle E.D.   Vlasveld A.C.   Audy J.   Quick D.  

Wear, Vol. 254, Iss. 7, 2003-04 ,pp. : 723-734

Elsevier

Access to resources Recommend Favorite