Surface finish parameters as diagnostics of tool wear in face milling

Author： Wilkinson P.   Reuben R.L.   Jones J.D.C.   Barton J.S.   Hand D.P.   Carolan T.A.   Kidd S.R.  

Publisher： Elsevier

ISSN： 0043-1648

Source： Wear, Vol.205, Iss.1, 1997-04, pp. : 47-54

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Influence of the relative positions of tool and workpiece on tool life, tool wear and surface finish in the face milling process

By Diniz A.E.   Filho J.C.  

Wear, Vol. 232, Iss. 1, 1999-09 ,pp. : 67-75

Elsevier

Access to resources Recommend Favorite

Tool wear monitoring in face milling using force signals

By Lin S.C.   Lin R.J.  

Wear, Vol. 198, Iss. 1, 1996-10 ,pp. : 136-142

Elsevier

Access to resources Recommend Favorite

Surface features as indicators of tool chipping in single point face milling of aluminium

By Wilkinson P.   Reuben R.L.   Jones J.D.C.   Barton J.S.   Hand D.P.   Carolan T.A.   Kidd S.R.  

Wear, Vol. 212, Iss. 2, 1997-12 ,pp. : 221-228

Elsevier

Access to resources Recommend Favorite

Effect of Tool Wear on Surface Qualities in Milling of TC4

By  

Materials Science Forum, Vol. 2016, Iss. 836, 2016-02 ,pp. : 132-138

Trans Tech Publications

Access to resources Recommend Favorite

The influence of cryogenic cooling on tool wear, dimensional accuracy and surface finish in turning AISI 1040 and E4340C steels

By Dhar N.R.   Paul S.   Chattopadhyay A.B.  

Wear, Vol. 249, Iss. 10, 2001-11 ,pp. : 932-942

Elsevier

Access to resources Recommend Favorite