Low friction surfaces for plastic injection moulding dies-an experimental case study

Author： dearnley P.A.  

Publisher： Elsevier

ISSN： 0043-1648

Source： Wear, Vol.225, Iss.2, 1999-04, pp. : 1109-1113

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

A study on elasto-plastic impact friction

By Nobre J.P.   Dias A.M.   Gras R.  

Wear, Vol. 230, Iss. 2, 1999-05 ,pp. : 133-145

Elsevier

Access to resources Recommend Favorite

Reduction of Injection Moulded Plastic Part Warpage Using Advanced Gas Assisted Injection Moulding

By  

Materials Science Forum, Vol. 2016, Iss. 862, 2016-09 ,pp. : 200-209

Trans Tech Publications

Access to resources Recommend Favorite

A study of the tribological behaviour of polyamide 66 with varying injection-moulding parameters

By Apichartpattanasiri S.   Hay J.N.   Kukureka S.N.  

Wear, Vol. 251, Iss. 1, 2001-10 ,pp. : 1557-1566

Elsevier

Access to resources Recommend Favorite

Wear of die materials in full scale plastic injection moulding of glass fibre reinforced polycarbonate

By Bergstrom J.   Thuvander F.   devos P.   Boher C.  

Wear, Vol. 251, Iss. 1, 2001-10 ,pp. : 1511-1521

Elsevier

Access to resources Recommend Favorite

Process Combination of Hydroforming and Injection Moulding for the In Situ Manufacturing of Metal and Plastic Composite Structures

By  

Materials Science Forum, Vol. 2015, Iss. 825, 2015-08 ,pp. : 522-529

Trans Tech Publications

Access to resources Recommend Favorite