Visualization Analysis of Flow Behavior During Weld-line Formation in Injection Molding Process

ISSN： 0360-2559

Source： Polymer-Plastics Technology and Engineering, Vol.47, Iss.7, 2008-07, pp. : 666-672

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Cavity Pressure Response and Melt Flow Length During Dynamic Injection Molding

By Hong-wu Wu hai-hang Xu Jin-ping Qu Shao-dan Zhang

Polymer-Plastics Technology and Engineering, Vol. 45, Iss. 8, 2006-01 ,pp. : 935-937

Taylor & Francis Ltd

Access to resources Recommend Favorite

Injection Molding Optimization for Minimizing the Defects of Weld Lines

By Deng Y. -M. Zheng D. Sun B. -S. Zhong H. -D.

Polymer-Plastics Technology and Engineering, Vol. 47, Iss. 9, 2008-09 ,pp. : 943-952

Taylor & Francis Ltd

Access to resources Recommend Favorite

Core Deflection in Plastics Injection Molding: Direct Measurement, Flow Visualization and 3D Simulation

By Chen Yi-Chang

Polymer-Plastics Technology and Engineering, Vol. 50, Iss. 9, 2011-06 ,pp. : 863-872

Taylor & Francis Ltd

Access to resources Recommend Favorite

Measurement and Analysis of Cavity Pressure and Melt Filling Capacity During Injection Molding

By Hong-wu Wu Shao-dan Zhang Jin-ping Qu Hai-hang Xu

Polymer-Plastics Technology and Engineering, Vol. 46, Iss. 2, 2007-02 ,pp. : 123-127

Taylor & Francis Ltd

Access to resources Recommend Favorite

Construction and Analysis in Combining the Taguchi Method and the Back Propagation Neural Network in the PEEK Injection Molding Process

By Kuo Chung-Feng Jeffrey

Polymer-Plastics Technology and Engineering, Vol. 46, Iss. 9, 2007-09 ,pp. : 841-848

Taylor & Francis Ltd

Access to resources Recommend Favorite