Construction and Analysis in Combining the Taguchi Method and the Back Propagation Neural Network in the PEEK Injection Molding Process

By Kuo Chung-Feng Jeffrey  

Polymer-Plastics Technology and Engineering, Vol. 46, Iss. 9, 2007-09 ,pp. : 841-848

Taylor & Francis Ltd

Access to resources Recommend Favorite

Optimization for Injection Molding Process Conditions of the Refrigeratory Top Cover Using Combination Method of Artificial Neural Network and Genetic Algorithms

By Shen Changyu  

Polymer-Plastics Technology and Engineering, Vol. 46, Iss. 2, 2007-02 ,pp. : 105-112

Taylor & Francis Ltd

Access to resources Recommend Favorite

Investigation of the Effect of Molding Variables on Sink Marks of Plastic Injection Molded Parts Using Taguchi DOE Technique

By Shen Changyu   Wang Lixia   Cao Wei   Qian Li  

Polymer-Plastics Technology and Engineering, Vol. 46, Iss. 3, 2007-03 ,pp. : 219-225

Taylor & Francis Ltd

Access to resources Recommend Favorite

Optimal Molding Parameter Design of PLA Micro Lancet Needles Using the Taguchi Method

By Wang Min-Wen   Jeng Jia-Haur  

Polymer-Plastics Technology and Engineering, Vol. 48, Iss. 7, 2009-07 ,pp. : 730-735

Taylor & Francis Ltd

Access to resources Recommend Favorite

Evaluation of process parameters using Taguchi methodology for blends of low density polyethylene (LDPE) and polydimethyl siloxane (PDMS) rubber

By Giri R   Naskar K   Nando G B  

Plastics, Rubber and Composites, Vol. 41, Iss. 8, 2012-10 ,pp. : 341-349

Maney Publishing

Access to resources Recommend Favorite