Experimental Investigation and Modeling of Plug-Flow Fluidized Bed Drying Under Steady-State Conditions

ISSN： 0737-3937

Source： Drying Technology, Vol.31, Iss.4, 2013-03, pp. : 414-432

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

In this study, a model for a plug-flow fluidized bed dryer under steady-state conditions was presented. The model was based on differential equations; thus the bed of the dryer was divided horizontally and vertically into major and minor control volumes, respectively. Each control volume was composed of two thermodynamic systems: solid and gas. The mass and energy balances of the particles in the major control volume based on the axial dispersion were developed to derive the axial profiles of solid moisture content and temperature. To derive the variation of gas humidity and temperature along the bed height and hence the axial profiles of outlet gas humidity and temperature, the mass and energy balances in the gas over the minor control volume, considering the plug flow of gas through the bed, were developed. The model was validated by comparing the simulation results with the experimental data obtained by drying the long-grain rough rice under steady-state conditions in a laboratory-scale, plug-flow fluidized bed dryer. A very satisfactory agreement between the simulation and the experimental data of solid moisture content, solid temperature, and outlet gas humidity and temperature was achieved. Also, the effects of inlet gas temperature, weir height, and inlet dry solid mass flow rate on the simulated axial profiles of solid moisture content and temperature, humidity difference between inlet and outlet gas, and outlet gas temperature were investigated.