ENHANCING THE DEPTH OF CUT IN ABRASIVE WATERJET CUTTING OF ALUMINA CERAMICS BY USING MULTIPASS CUTTING WITH NOZZLE OSCILLATION

Author： Wang J.   Zhong Y.  

Publisher： Taylor & Francis Ltd

ISSN： 1091-0344

Source： Machining Science and Technology, Vol.13, Iss.1, 2009-01, pp. : 76-91

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

The Depth of Cut in Drilling Mode of Rock Cutting

By  

Applied Mechanics and Materials, Vol. 2017, Iss. 873, 2017-12 ,pp. : 292-297

Trans Tech Publications

Access to resources Recommend Favorite

Aspects of Machining Parameter Effect on Cut Quality in Abrasive Water Jet Cutting

By  

Applied Mechanics and Materials, Vol. 2015, Iss. 809, 2015-12 ,pp. : 201-206

Trans Tech Publications

Access to resources Recommend Favorite

Rapid Determining of the Optimum Operation Mode for Abrasive Waterjet Cutting Process by Means of Acoustic Emission

By  

Applied Mechanics and Materials, Vol. 2014, Iss. 698, 2015-01 ,pp. : 401-404

Trans Tech Publications

Access to resources Recommend Favorite

Optimization of Cutting Conditions in Multi-Pass Milling

By  

Applied Mechanics and Materials, Vol. 2016, Iss. 823, 2016-02 ,pp. : 525-530

Trans Tech Publications

Access to resources Recommend Favorite

Application of High-Strength Gradient Cutting Ceramics with a Multifunctional Coating for Heavy Machining of Hard-to-Cut Materials

By  

Applied Mechanics and Materials, Vol. 2015, Iss. 798, 2015-11 ,pp. : 344-350

Trans Tech Publications

Access to resources Recommend Favorite