AN INVESTIGATION INTO DIMENSIONAL ACCURACY AND SURFACE FINISH ACHIEVABLE IN DRY TURNING

ISSN： 1091-0344

Source： Machining Science and Technology, Vol.13, Iss.4, 2009-10, pp. : 571-589

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

EFFECT OF ADDITIONAL FACTORS ON DIMENSIONAL ACCURACY AND SURFACE FINISH OF TURNED PARTS

By Islam M. N.

Machining Science and Technology, Vol. 17, Iss. 1, 2013-01 ,pp. : 145-162

Taylor & Francis Ltd

Access to resources Recommend Favorite

FUZZY CLUSTERING MODELLING FOR SURFACE FINISH PREDICTION IN FINE TURNING PROCESS

By Hayajneh Mohammed

Machining Science and Technology, Vol. 9, Iss. 3, 2005-01 ,pp. : 437-451

Taylor & Francis Ltd

Access to resources Recommend Favorite

Statistical investigation of modal parameters of cutting tools in dry turning

By Thomas M. Beauchamp Y.

International Journal of Machine Tools and Manufacture, Vol. 43, Iss. 11, 2003-09 ,pp. : 1093-1106

Elsevier

Access to resources Recommend Favorite

Surface Roughness Prediction During Dry Turning of Austenitic Stainless Steel AISI 304

Applied Mechanics and Materials, Vol. 2015, Iss. 808, 2015-12 ,pp. : 54-59

Trans Tech Publications

Access to resources Recommend Favorite

Taguchi Approach for the Optimization of Cutting Parameters in Finish Turning of Medical Stainless Steel

Applied Mechanics and Materials, Vol. 2015, Iss. 809, 2015-12 ,pp. : 153-158

Trans Tech Publications

Access to resources Recommend Favorite