TOOL WEAR AND SURFACE FINISH IN HIGH SPEED MILLING OF ALUMINUM BRONZE

Author： Medicus K.   Davies M.   Dutterer B.   Evans C.   Fielder R.  

Publisher： Taylor & Francis Ltd

ISSN： 1091-0344

Source： Machining Science and Technology, Vol.5, Iss.2, 2001-01, pp. : 255-268

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Investigation of surface integrity in high speed end milling of a low alloyed steel

By Chevrier P.   Tidu A.   Bolle B.   Cezard P.   Tinnes J.P.  

International Journal of Machine Tools and Manufacture, Vol. 43, Iss. 11, 2003-09 ,pp. : 1135-1142

Elsevier

Access to resources Recommend Favorite

A Study of Abrasive Wear on High Speed Steel Surface in Hot Rolling

By  

Applied Mechanics and Materials, Vol. 2016, Iss. 846, 2016-09 ,pp. : 589-594

Trans Tech Publications

Access to resources Recommend Favorite

Investigating the Effect of Cutting Speed Variation on Surface Roughness of 7136 Aluminum Alloy in End Milling

By  

Applied Mechanics and Materials, Vol. 2015, Iss. 809, 2015-12 ,pp. : 129-134

Trans Tech Publications

Access to resources Recommend Favorite

The Study of Tool Wear Performance on Pocket Milling Strategy

By  

Applied Mechanics and Materials, Vol. 2014, Iss. 699, 2015-01 ,pp. : 64-69

Trans Tech Publications

Access to resources Recommend Favorite

Improvement of Wear Performance of High Speed Steel Tool Using Physical Vapour Deposition Coating Process

By  

Applied Mechanics and Materials, Vol. 2015, Iss. 787, 2015-09 ,pp. : 391-395

Trans Tech Publications

Access to resources Recommend Favorite