A METHOD TO ESTIMATE THE AVERAGE TEMPERATURE ON THE CUTTING EDGE OF TOOLS: APPLICATION ON THE MILLING PROCESS

Author： Elmoussami Haj  

Publisher： Taylor & Francis Ltd

ISSN： 1521-0480

Source： Experimental Heat Transfer, Vol.16, Iss.2, 2003-04, pp. : 139-158

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Prediction of Cutting Forces in Milling Stainless Steels using Chamfered Main Cutting Edge Tool

By  

Journal of Mechanics, Vol. 21, Iss. 3, 2005-09 ,pp. : 145-155

Cambridge University Press

Access to resources Recommend Favorite

Development of a Tri-Axial Cutting Force Sensor for the Milling Process

By Li Yingxue   Zhao Yulong   Fei Jiyou   Zhao You   Li Xiuyuan   Gao Yunxiang  

Sensors, Vol. 16, Iss. 3, 2016-03 ,pp. : 405-405

MDPI

Access to resources Recommend Favorite

An Experimental Method for the Cutting Process in Three Dimensions

By  

Le Journal de Physique IV, Vol. 07, Iss. C3, 1997-08 ,pp. : C3-21-C3-26

Edp Sciences

Access to resources Recommend Favorite

Automatic registration method for multisensor datasets adopted for dimensional measurements on cutting tools

By Shaw L.   Ettl S.   Mehari F.   Weckenmann A.   Häusler G.  

Measurement Science and Technology, Vol. 24, Iss. 4, 2013-04 ,pp. : 45002-45009

IOP Publishing

Access to resources Recommend Favorite

EXPERIMENTAL AND NUMERICAL METHOD FOR DETERMINING TEMPERATURE DISTRIBUTION IN A WOOD CUTTING TOOL

By Sheikh-Ahmad J. Y.  

Experimental Heat Transfer, Vol. 16, Iss. 4, 2003-10 ,pp. : 255-271

Taylor & Francis Ltd

Access to resources Recommend Favorite