APPROXIMATE MODEL OF THERMAL RESIDUAL STRESS IN AN INJECTION MOLDED PART

Author： Zhang X. Cheng X. Stelson K. A. Bhattacharya M. Sen A. Voller V. R.

ISSN： 0149-5739

Source： Journal of Thermal Stresses, Vol.25, Iss.6, 2002-06, pp. : 523-538

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

The Thermal Residual Stress Redistribution in a Bamboo Interconnect

By Chen Na

Journal of Thermal Stresses, Vol. 31, Iss. 7, 2008-07 ,pp. : 638-648

Taylor & Francis Ltd

Access to resources Recommend Favorite

THERMAL STRESS MODEL FOR POLYMER SENSORS

By Rakowski Wieslaw Kot Marcin

Journal of Thermal Stresses, Vol. 28, Iss. 1, 2004-01 ,pp. : 17-28

Taylor & Francis Ltd

Access to resources Recommend Favorite

Hamiltonian Approach to Analytical Thermal Stress Intensity Factors—Part 2 Thermal Stress Intensity Factor

By Leung Andrew

Journal of Thermal Stresses, Vol. 33, Iss. 3, 2010-03 ,pp. : 279-301

Taylor & Francis Ltd

Access to resources Recommend Favorite

Hamiltonian Approach to Analytical Thermal Stress Intensity Factors—Part 1: Thermal Intensity Factor

By Leung Andrew

Journal of Thermal Stresses, Vol. 33, Iss. 3, 2010-03 ,pp. : 262-278

Taylor & Francis Ltd

Access to resources Recommend Favorite

Thermal conductivity measurements of alumina powders and molded Min-K in vacuum

By Huang L. El-Genk M.S.

Energy Conversion and Management, Vol. 42, Iss. 5, 2001-03 ,pp. : 599-612

Elsevier

Access to resources Recommend Favorite