Numerical Analysis of Ultrashort Pulse Laser-Induced Thermomechanical Response of Germanium Thin Films

ISSN： 1556-7265

Source： Nanoscale and Microscale Thermophysical Engineering, Vol.16, Iss.4, 2012-12, pp. : 274-287

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Ultrashort pulse laser heating of a germanium nanofilm was simulated using a combined continuum–atomistic method that couples the molecular dynamics and a self-consistent energy model for ultrafast laser–semiconductor interaction. Both a single pulse and a pulse burst were considered. To accurately describe laser energy deposition, the transient optical properties were computed based on the Drude formula. It was found that for a single pulse at low fluence (e.g., 0.02 J/cm²), the pulse duration had little impact on the lattice temperature response. In contrast, a higher lattice temperature could be obtained for a longer pulse (e.g., 5 ps) at higher fluences (e.g., 0.06 J/cm²) due to lower surface reflectivity. A strong thermal stress wave could be induced by the laser heating, with its maximum compression and tension occurring in the front and rear film regions, respectively. The investigations of laser burst heating revealed that a laser burst not only can retain the advantages of ultrashort pulse lasers but can enhance the photon efficiency for material melting as well.