Effects of debinding parameters on powder injection molded Ti-6Al-4V/HA composite parts

Author： Thian E. S. Loh N. H. Khor K. A. Tor S. B.

Publisher： VSP

ISSN： 1568-5527

Source： Advanced Powder Technology, Vol.12, Iss.3, 2001-09, pp. : 361-370

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Effects of Processing Parameters on Tensile Strength of Thin-Wall HDPE Parts Injection Molded by Ultra High-Speed Process

By Chen Shia-Chung Li Hai-Mei

Polymer-Plastics Technology and Engineering, Vol. 50, Iss. 3, 2011-01 ,pp. : 276-281

Taylor & Francis Ltd

Access to resources Recommend Favorite

Elucidation of microstructure and wear behaviors of Ti-6Al-4V cladding using tungsten boride powder by the GTAW method

By Lin Yuan-Ching

JCT Research, Vol. 8, Iss. 2, 2011-03 ,pp. : 247-253

Springer Publishing Company

Access to resources Recommend Favorite

Characteristics of the Skin Layers of Microcellular Injection Molded Parts

By Lee Jung Cha Sung

Polymer-Plastics Technology and Engineering, Vol. 45, Iss. 7, 2006-01 ,pp. : 871-877

Taylor & Francis Ltd

Access to resources Recommend Favorite

Numerical simulation of two-dimensional wick debinding in metal powder injection molding

By Chang Chih-Yuan

Advanced Powder Technology, Vol. 14, Iss. 2, 2003-06 ,pp. : 177-194

VSP

Access to resources Recommend Favorite

Effects of processing parameters on formation of sinkmarks on injection moulded parts

By Liu S-J.

Plastics, Rubber and Composites, Vol. 30, Iss. 4, 2001-04 ,pp. : 170-174

Maney Publishing

Access to resources Recommend Favorite