The influence of granule morphology on attrition during fluidization and pneumatic transport

Publisher： VSP

ISSN： 1568-5527

Source： Advanced Powder Technology, Vol.3, Iss.3, 1992-01, pp. : 201-218

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Influence of Fines Concentration on Pneumatic Transport Capacity of Alumina

By DATTA B. K.

Particulate Science and Technology, Vol. 21, Iss. 3, 2003-07 ,pp. : 283-291

Taylor & Francis Ltd

Access to resources Recommend Favorite

Numerical Study of Air Compressibility During Horizontal Pneumatic Transport

By TASHIRO H.

Particulate Science and Technology, Vol. 22, Iss. 2, 2004-04 ,pp. : 139-149

Taylor & Francis Ltd

Access to resources Recommend Favorite

A preliminary study on the transport disengaging height in particulate fluidization

By Dubey S. Ganguly U.P.

Fuel and Energy Abstracts, Vol. 39, Iss. 3, 1998-05 ,pp. : 229-230

Elsevier

Access to resources Recommend Favorite

Attrition of Bulk Solids in Pneumatic Conveying: Mechanisms and Material Properties

By FRYE L. PEUKERT W.

Particulate Science and Technology, Vol. 20, Iss. 4, 2002-10 ,pp. : 267-282

Taylor & Francis Ltd

Access to resources Recommend Favorite

A COMPARISON OF PARTICLE WEAR IN PNEUMATIC TRANSPORT

By Borzone Luis

Chemical Engineering Communications, Vol. 197, Iss. 9, 2010-09 ,pp. : 1215-1224

Taylor & Francis Ltd

Access to resources Recommend Favorite