Author： Al-Harthi M. Kahraman R. Yilbas B. Sunar M. Aleem B. J. Abdul
Publisher： Taylor & Francis Ltd
ISSN： 1568-5616
Source： Journal of Adhesion Science and Technology, Vol.18, Iss.15-16, 2004-01, pp. : 1699-1710
Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.
Abstract
Durability of adhesively-bonded aluminum joints was investigated by measuring the joint strength using the single-lap shear test before and after exposure to distilled water and seawater. Fractured specimens were examined by photography and scanning electron microscopy to determine the failure modes. Addition of Al particles as much as 50 wt% did not cause any significant decrease in adhesive joint strength. Moreover, varying the Al filler content in the adhesive did not have a significant effect on adhesive behavior in either of the two environments studied. The unexposed adhesive joints failed almost completely in a cohesive (in the adhesive) failure mode. Some decrease in strength was observed in adhesive joints after exposure to both distilled water and seawater for 6 months. The decrease in adhesive joint strength was more significant for specimens immersed in distilled water than those immersed in seawater, probably due to the higher amount of moisture in the adhesive in distilled water than in seawater, as observed in a related moisture diffusion study. The joints exposed to distilled water or sea water failed in more than one mode. The interior part of the adhesive lap area failed in a cohesive mode while an adhesion failure mode was observed near the edges of the adhesive lap area, which is believed to be a result of moisture diffusion through the edges.
Related content
Access to resources
Recommend
Fatigue initiation in adhesively-bonded single-lap joints
Journal of Adhesion Science and Technology, Vol. 21, Iss. 14, 2007-10 ,pp. :
Journal of Adhesion Science and Technology, Vol. 14, Iss. 1, 2000-01 ,pp. :