Optimization of Residual Stresses in the Surface Regions of Injection Moldings

ISSN： 0360-2559

Source： Polymer-Plastics Technology and Engineering, Vol.49, Iss.1, 2010-01, pp. : 32-37

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

The effect of residual stresses on adhesion measurements

By Thouless M.D.

Journal of Adhesion Science and Technology, Vol. 8, Iss. 6, 1994-01 ,pp. : 579-586

Taylor & Francis Ltd

Access to resources Recommend Favorite

Determination of residual stresses in coated metallic substrates

By Bouchet J.

Journal of Adhesion Science and Technology, Vol. 15, Iss. 3, 2001-02 ,pp. : 321-343

Taylor & Francis Ltd

Access to resources Recommend Favorite

Residual stresses and practical adhesion: effect of organo-metallic complex formation and crystallization

By Aufray Maëlenn Roche Alain André

Journal of Adhesion Science and Technology, Vol. 20, Iss. 16, 2006-12 ,pp. : 1889-1903

Taylor & Francis Ltd

Access to resources Recommend Favorite

Predicting residual stresses due to solidification in cast plastic plates

By Tropsa V. Ivankovic A. Williams J.G.

Plastics, Rubber and Composites, Vol. 29, Iss. 9, 2000-09 ,pp. : 468-474

Maney Publishing

Access to resources Recommend Favorite

Thermal residual stresses in an adhesively-bonded functionally graded single-lap joint

By Apalak M. Kemal Gunes Recep

Journal of Adhesion Science and Technology, Vol. 20, Iss. 12, 2006-09 ,pp. : 1295-1320

Taylor & Francis Ltd

Access to resources Recommend Favorite