Construction of an artifact to the suitability of sitting posture in children with cerebral palsy and multiple disabilities

Author： Schewtschik Ana Carolina de Oliveira Evandro Santiago de Vasconcelos Moreira Izaura Ribas Cristiane Gonçalves Cunha Loureiro Ana Paula

Publisher： Informa Healthcare

ISSN： 1748-3107

Source： Disability and Rehabilitation: Assistive Technology, Vol.8, Iss.6, 2013-11, pp. : 502-506

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

AbstractIntroduction: Cerebral palsy (CP) may involve muscle imbalance between the spastic muscles and their antagonists leading to weak postural changes, decreased mobility and chest deformities. Objective: To improve postural condition in children with CP using physiotherapy and assistive technology (AT). Materials and methods: Five children with CP and multiple disabilities and postural changes like scoliosis were included in this study. AT involved the use of low-cost custom made cushion seat and backrest for the wheelchairs to achieve 90° of trunk flexion. This was performed in 10 sessions after the beginning of physiotherapy. As evaluation-intervention tool, photographs were taken at the beginning and end of each session, and then analyzed using software for postural assessment (SAPO). Results: Twenty-five per cent of the participants had an improvement of trunk angulations at the end of the treatment program. Conclusion: The use of AT with physiotherapy treatment proved efficient in the postural alignment of children with CP children in a wheelchair.Implications for RehabilitationWheelchairs are manufactured in standard size, which makes difficult the adaptation of individuals with peculiar postures. Even the most sophisticated, with adjustments and special accessories, not always allow adjustments to shape up properly to deformities in children with cerebral palsy.It is hoped that this research will be useful in order to show rehabilitation professionals the ability to minimize the difficulties of keeping children with cerebral palsy and multiple disabilities properly seated in the wheelchair, facilitating posture, movement, breathing and swallowing.The construction of these artifacts has the advantage of being low cost, and must pass through stages of adequacy and modeling in order to replace the seat and side of the wheelchair.