Effect of homogenisation cooling rate and press exit temperature on extrudability and T5 hardness of EN AW 6082 alloy

ISSN： 1743-2847

Source： Materials Science and Technology, Vol.29, Iss.12, 2013-12, pp. : 1518-1521

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Adherence of Electrodeposited Zn–Ni Coatings on EN AW2024 T3 Aluminium Alloy

By Alexis J. Adrian D. Masri T. Petit J.A.

Surface Engineering, Vol. 20, Iss. 2, 2004-04 ,pp. : 121-127

Maney Publishing

Access to resources Recommend Favorite

Extrusion of EN AW-2014 alloy in semisolid state

By Birol Y Guven E A Capan L J

Materials Science and Technology, Vol. 27, Iss. 12, 2011-12 ,pp. : 1851-1857

Maney Publishing

Access to resources Recommend Favorite

Heat treatment of thixoformed EN AW 7075 alloy

By Birol Y

Materials Science and Technology, Vol. 28, Iss. 6, 2012-06 ,pp. : 651-657

Maney Publishing

Access to resources Recommend Favorite

Effect of cooling rate on solidification characteristics of aluminium alloy AA 5182

By Thompson S. Cockcroft S. L. Wells M. A.

Materials Science and Technology, Vol. 20, Iss. 4, 2004-04 ,pp. : 497-504

Maney Publishing

Access to resources Recommend Favorite

Effect of homogenisation conditions on recrystallisation in Al–Mg–Mn alloy AA 5454

By Osman M. Engler O. Karhausen K. Löchte L. McLaren A. J.

Materials Science and Technology, Vol. 23, Iss. 6, 2007-06 ,pp. : 688-698

Maney Publishing

Access to resources Recommend Favorite