The Influence of Textural and Compositional Characteristics of Nafion/Silica Composites on Isobutane/2-Butene Alkylation

Author： Botella P. Corma A. López-Nieto J.M.

Publisher： Academic Press

ISSN： 0021-9517

Source： Journal of Catalysis, Vol.185, Iss.2, 1999-07, pp. : 371-377

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Nafion/silica composites of different surface areas and polymer contents were prepared using a sol–gel technique. Their catalytic behavior was measured for the liquid phase alkylation of isobutane with 2-butene. A maximum initial (TOS=1 min) activity and selectivity to trimethylpentanes as well as slower decay were detected for the sample with the smallest surface area (10 m²g^-1) and a Nafion content of 20 wt%. Catalysts with the same polymer content but a larger surface area showed a considerably lower initial activity and selectivity; deactivation was faster. This can be explained by the fact that, in composites with a greater surface area—highly dispersed Nafion—the sulfonic groups of the polymer interact to a greater extent with the silanol groups of the silica, resulting in a decrease in the activity of the sulfonic groups. In the same way, when the Nafion content is varied in those composites with a large and similar BET area, the rates of deactivation are inversely proportional to the amount of resin in the sample. Moreover, a silica-supported Nafion catalyst, prepared by impregnation, has given results as good as those obtained with the more active Nafion/silica composite. The effect of the process variables (TOS, temperature, and isoparaffin/olefin molar ratio) on the activity and selectivity of these catalysts was studied as well. Comparison of these catalysts with other solid acid materials, such as an H-Beta zeolite and a sulfated zirconia, shows that the Nafion/silica samples behave more like H-Beta than like the sulfated zirconia catalyst.