Experimental design approach to optimize selective laser melting of martensitic 17-4 PH powder: part I ‐ single laser tracks and first layer

Author： Averyanova M.   Cicala E.   Bertrand Ph.   Grevey Dominique  

Publisher： Emerald Group Publishing Ltd

ISSN： 1355-2546

Source： Rapid Prototyping Journal, Vol.18, Iss.1, 2012-01, pp. : 28-37

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Residual stresses in selective laser sintering and selective laser melting

By Mercelis Peter   Kruth Jean-Pierre  

Rapid Prototyping Journal, Vol. 12, Iss. 5, 2006-10 ,pp. : 254-265

Emerald Group Publishing Ltd

Access to resources Recommend Favorite

Binding mechanisms in selective laser sintering and selective laser melting

By Kruth J-P.   Mercelis P.   Vaerenbergh J. Van   Froyen L.   Rombouts M.  

Rapid Prototyping Journal, Vol. 11, Iss. 1, 2005-02 ,pp. : 26-36

Emerald Group Publishing Ltd

Access to resources Recommend Favorite

Study on formation of surface and microstructure of stainless steel part produced by selective laser melting

By Jinhui L.   Ruidi L.   Wenxian Z.   Liding F.   Huashan Y.  

Materials Science and Technology, Vol. 26, Iss. 10, 2010-10 ,pp. : 1259-1264

Maney Publishing

Access to resources Recommend Favorite

Application of dimensional analysis to selective laser melting

By Elsen Maarten van   Al-Bender Farid   Kruth Jean-Pierre  

Rapid Prototyping Journal, Vol. 14, Iss. 1, 2008-01 ,pp. : 15-22

Emerald Group Publishing Ltd

Access to resources Recommend Favorite

An integrated cost-model for selective laser melting (SLM)

By Rickenbacher L.   Spierings A.   Wegener K.  

Rapid Prototyping Journal, Vol. 19, Iss. 3, 2013-04 ,pp. : 208-214

Emerald Group Publishing Ltd

Access to resources Recommend Favorite