Mechanical characteristics of fiber-filled photo-polymer used in stereolithography

Author： Cheah C.M.   C. J.Y.H. Fuh A. Y.   Nee A.Y.C.   Lu L  

Publisher： Emerald Group Publishing Ltd

ISSN： 1355-2546

Source： Rapid Prototyping Journal, Vol.5, Iss.3, 1999-03, pp. : 112-119

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Curing characteristics of acrylic photopolymer used in stereolithography process

By Shen J.Y.H. Fuh L Lu C.C. Tan Z.X.   Chew S  

Rapid Prototyping Journal, Vol. 5, Iss. 1, 1999-01 ,pp. : 27-34

Emerald Group Publishing Ltd

Access to resources Recommend Favorite

Effect of Small Additions of Stabilizer and Pigments on the Degree of Bulk Curing of a Filled Photopolymer

By Starokadomskii D.L.   Solov'eva T.N.  

Russian Journal of Applied Chemistry, Vol. 76, Iss. 4, 2003-04 ,pp. : 616-618

MAIK Nauka/Interperiodica

Access to resources Recommend Favorite

Tests on reinforced-concrete-filled, fiber-reinforced-polymer circular tubes of different shear spans

By Fam Amir   Cole Britton  

Canadian Journal of Civil Engineering, Vol. 34, Iss. 3, 2007-03 ,pp. : 311-322

NRC Research Press

Access to resources Recommend Favorite

Influence of layer thickness on mechanical properties in stereolithography

By Chockalingam K.   Jawahar N.   Chandrasekhar U.  

Rapid Prototyping Journal, Vol. 12, Iss. 2, 2006-03 ,pp. : 106-113

Emerald Group Publishing Ltd

Access to resources Recommend Favorite

Effects of interface characteristics on mechanical properties of carbon nanotube reinforced polymer composites

By Shojaie M   Golestanian H  

Materials Science and Technology, Vol. 27, Iss. 5, 2011-05 ,pp. : 916-922

Maney Publishing

Access to resources Recommend Favorite