Specifying non-uniform cusp heights as a potential aid for adaptive slicing

Author： Cormier Denis Unnanon Kittinan Sanii Ezat

ISSN： 1355-2546

Source： Rapid Prototyping Journal, Vol.6, Iss.3, 2000-03, pp. : 204-212

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Adaptive direct slicing with non-uniform cusp heights for rapid prototyping

By Zhou M. Xi J. Yan J.

The International Journal of Advanced Manufacturing Technology, Vol. 23, Iss. 1-2, 2004-01 ,pp. : 20-27

Springer Publishing Company

Access to resources Recommend Favorite

Adaptive slicing using stepwise uniform refinement

By Sabourin Emmanuel Houser Scott A Bøhn Jan Helge

Rapid Prototyping Journal, Vol. 2, Iss. 4, 1996-04 ,pp. : 20-26

Emerald Group Publishing Ltd

Access to resources Recommend Favorite

Local adaptive slicing

By Tyberg Justin Bøhn Jan Helge

Rapid Prototyping Journal, Vol. 4, Iss. 3, 1998-03 ,pp. : 118-127

Emerald Group Publishing Ltd

Access to resources Recommend Favorite

Adaptive slicing with sloping layer surfaces

By Hope R.L. Roth R.N. Jacobs P.A.

Rapid Prototyping Journal, Vol. 3, Iss. 3, 1997-03 ,pp. : 89-98

Emerald Group Publishing Ltd

Access to resources Recommend Favorite

Adaptive slicing with cubic patch approximation

By Kumar Madhup Choudhury A Roy

Rapid Prototyping Journal, Vol. 8, Iss. 4, 2002-08 ,pp. : 224-232

Emerald Group Publishing Ltd

Access to resources Recommend Favorite