Release behavior for powder injection molding in stereolithography molds

Author： Hemrick James G   Starr Thomas L   Rosen David W  

Publisher： Emerald Group Publishing Ltd

ISSN： 1355-2546

Source： Rapid Prototyping Journal, Vol.7, Iss.2, 2001-04, pp. : 115-121

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Simulation of injection molding into rapid-prototyped molds

By Aluru Rajitha   Keefe Michael   Advani Suresh  

Rapid Prototyping Journal, Vol. 7, Iss. 1, 2001-03 ,pp. : 42-51

Emerald Group Publishing Ltd

Access to resources Recommend Favorite

Experimental study of post-build cure of stereolithography polymers for injection molds

By Colton Jonathan   Blair Bryan  

Rapid Prototyping Journal, Vol. 5, Iss. 2, 1999-06 ,pp. : 72-81

Emerald Group Publishing Ltd

Access to resources Recommend Favorite

Powder injection molding 440C stainless steel

By Li Duxin   Hou Haitao   Liang Lianghua   Lee Kun  

The International Journal of Advanced Manufacturing Technology, Vol. 49, Iss. 1-4, 2010-07 ,pp. : 105-110

Springer Publishing Company

Access to resources Recommend Favorite

Obtaining of Biopolymer from Onion Used as a Binder in Powder Injection Molding Process

By  

Advanced Engineering Forum, Vol. 2018, Iss. 27, 2018-06 ,pp. : 50-55

Trans Tech Publications

Access to resources Recommend Favorite

Stereolithography for injection mould tooling

By Rahmati Sadegh   Dickens Philip  

Rapid Prototyping Journal, Vol. 3, Iss. 2, 1997-02 ,pp. : 53-60

Emerald Group Publishing Ltd

Access to resources Recommend Favorite