Laser path planning of burn-out rule for LOM process

ISSN： 1355-2546

Source： Rapid Prototyping Journal, Vol.9, Iss.4, 2003-04, pp. : 201-211

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Effect of path planning on the laser powder deposition process: thermal and structural evaluation

By Foroozmehr Ehsan Kovacevic Radovan

The International Journal of Advanced Manufacturing Technology, Vol. 51, Iss. 5-8, 2010-11 ,pp. : 659-669

Springer Publishing Company

Access to resources Recommend Favorite

Characterization of the laminated object manufacturing (LOM) process

By Park Joon Tari Michael J Hahn H Thomas

Rapid Prototyping Journal, Vol. 6, Iss. 1, 2000-01 ,pp. : 36-50

Emerald Group Publishing Ltd

Access to resources Recommend Favorite

Thermomechanical analysis of the laminated object manufacturing (LOM) process

By Sonmez Fazil O Hahn H Thomas

Rapid Prototyping Journal, Vol. 4, Iss. 1, 1998-01 ,pp. : 26-36

Emerald Group Publishing Ltd

Access to resources Recommend Favorite

Development of a curved layer LOM process for monolithic ceramics and ceramic matrix composites

By Klosterman Donald A. Chartoff Richard P. Osborne Nora R. Graves George A. Lightman Allan Han Gyoowan Bezeredi Akos Rodrigues Stan

Rapid Prototyping Journal, Vol. 5, Iss. 2, 1999-06 ,pp. : 61-71

Emerald Group Publishing Ltd

Access to resources Recommend Favorite

An experimental investigation of the surface roughness of parts produced by LOM process

By Kechagias John

Rapid Prototyping Journal, Vol. 13, Iss. 1, 2007-01 ,pp. : 17-22

Emerald Group Publishing Ltd

Access to resources Recommend Favorite