A comparative evaluation of industrial design models produced using rapid prototyping and workshop-based fabrication techniques

Author： Evans Mark A.   Campbell R. Ian  

Publisher： Emerald Group Publishing Ltd

ISSN： 1355-2546

Source： Rapid Prototyping Journal, Vol.9, Iss.5, 2003-12, pp. : 344-351

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Fabrication of customised scaffolds using computer-aided design and rapid prototyping techniques

By Naing M.W.   Chua C.K.   Leong K.F.   Wang Y.  

Rapid Prototyping Journal, Vol. 11, Iss. 4, 2005-09 ,pp. : 249-259

Emerald Group Publishing Ltd

Access to resources Recommend Favorite

Design and fabrication of a hybrid surface-pressure airfoil model based on rapid prototyping

By Zhou Zhihua   Li Dichen   Zhang Zhengyu   Zeng Junhua  

Rapid Prototyping Journal, Vol. 14, Iss. 1, 2008-01 ,pp. : 57-66

Emerald Group Publishing Ltd

Access to resources Recommend Favorite

Prosthetic sockets fabrication using rapid prototyping technology

By Ng P   Lee P.S.V.   Goh J.C.H.  

Rapid Prototyping Journal, Vol. 8, Iss. 1, 2002-01 ,pp. : 53-59

Emerald Group Publishing Ltd

Access to resources Recommend Favorite

Fabrication of artificial bioactive bone using rapid prototyping

By Chen Zhongzhong   Li Dichen   Lu Bingheng   Tang Yiping   Sun Minglin   Wang Zhen  

Rapid Prototyping Journal, Vol. 10, Iss. 5, 2004-12 ,pp. : 327-333

Emerald Group Publishing Ltd

Access to resources Recommend Favorite

A comparison of rapid prototyping techniques used for wind tunnel model fabrication

By Chuk Raymond N   Thomson Vincent J  

Rapid Prototyping Journal, Vol. 4, Iss. 4, 1998-04 ,pp. : 185-196

Emerald Group Publishing Ltd

Access to resources Recommend Favorite