Analysis and optimisation of cutting parameters for surface roughness in machining Al/SiC particulate composites by PCD tool

By Palanikumar K.   Shanmugam K.   Davim J. Paulo  

International Journal of Materials and Product Technology, Vol. 37, Iss. 1-2, 2009-11 ,pp. : 117-128

Inderscience Publishers

Access to resources Recommend Favorite

Influence of machining parameters on surface roughness in finish cut of WEDM

By Han Fuzhu   Jiang Jun   Yu Dingwen  

The International Journal of Advanced Manufacturing Technology, Vol. 34, Iss. 5-6, 2007-09 ,pp. : 538-546

Springer Publishing Company

Access to resources Recommend Favorite

Optimization of Process Parameters for Surface Roughness in Ultrasonic Machining of Polycarbonate Bullet Proof Glass and Acrylic Heat Resistant Glass by Taguchi and Grey Relational Analysis Approach

By  

Advanced Engineering Forum, Vol. 2017, Iss. 23, 2017-09 ,pp. : 21-44

Trans Tech Publications

Access to resources Recommend Favorite

The effect of machining parameters on surface roughness and material removal rate with cryogenic treated wire in WEDM

By Kapoor Jatinder   Khamba Jaimal Singh   Singh Sehijpal  

International Journal of Machining and Machinability of Materials, Vol. 12, Iss. 1-2, 2012-08 ,pp. : 126-141

Inderscience Publishers

Access to resources Recommend Favorite

A study on optimisation of cutting parameters and prediction of surface roughness in end milling of aluminium under MQL machining

By Murthy K. Sundara   Rajendran I.  

International Journal of Machining and Machinability of Materials, Vol. 7, Iss. 1-2, 2009-12 ,pp. : 112-128

Inderscience Publishers

Access to resources Recommend Favorite