Finite element calculation of thermomechanical stresses in candidate ceramic components for press and blow moulds

Author： Brauns E.   Patyn J.   Wiersema E.   Skerath A.  

Publisher： Society of Glass Technology

ISSN： 0017-1050

Source： Glass Technology - European Journal of Glass Science and Technology Part A, Vol.40, Iss.2, 1999-04, pp. : 58-64

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Finite element thermal analysis of special building components

By Agnoletto L.  

Fuel and Energy Abstracts, Vol. 36, Iss. 5, 1995-09 ,pp. : 364-364

Elsevier

Access to resources Recommend Favorite

Smart moulds for cost effective components

By  

Reinforced Plastics, Vol. 47, Iss. 10, 2003-11 ,pp. : 30-34

Elsevier

Access to resources Recommend Favorite

Finite element simulation of cold isostatic pressing and sintering of SiC components

By Reiterer M.   Kraft T.   Janosovits U.   Riedel H.  

Ceramics International, Vol. 30, Iss. 2, 2004-01 ,pp. : 177-183

Elsevier

Access to resources Recommend Favorite

Prediction of hysteretic temperature increase in rubber components by finite element analysis

By Sae-oui P.   Freakley P.K.   Oubridge P.S.  

Plastics, Rubber and Composites, Vol. 28, Iss. 2, 1999-02 ,pp. : 69-73

Maney Publishing

Access to resources Recommend Favorite

Prediction of fatigue crack growth using finite element analysis techniques applied to three-dimensional elastomeric components

By Busfield J. J. C.   Jha V.   Liang H.   Papadopoulos I. C.   Thomas A. G.  

Plastics, Rubber and Composites, Vol. 34, Iss. 8, 2005-10 ,pp. : 349-356

Maney Publishing

Access to resources Recommend Favorite