A reverse engineering approach to the design of the blank mould for the glass blow and blow process

Author： Lochegnies D.   Moreau P   Guilbaut R.  

Publisher： Society of Glass Technology

ISSN： 0017-1050

Source： Glass Technology - European Journal of Glass Science and Technology Part A, Vol.46, Iss.2, 2005-04, pp. : 116-120

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Simulation and improvement of blank and blow mould cooling in the hollow glass forming process

By Bewer Thomas  

Glass Technology - European Journal of Glass Science and Technology Part A, Vol. 49, Iss. 4, 2008-08 ,pp. : 168-174

Society of Glass Technology

Access to resources Recommend Favorite

Blow moulding of long glass fibre composites

By Bush S.F.   Dreiza M.    

Plastics, Rubber and Composites, Vol. 28, Iss. 8, 1999-08 ,pp. : 379-384

Maney Publishing

Access to resources Recommend Favorite

Heat transfer in glass container production during the final blow

By Keijts G.   van der Werff K.  

Glass Technology - European Journal of Glass Science and Technology Part A, Vol. 42, Iss. 3, 2001-06 ,pp. : 104-108

Society of Glass Technology

Access to resources Recommend Favorite

Production of rare-earth orthoferrite ceramic fibres by aqueous sol-gel blow spinning process

By Rajendran M.   Bhattacharya A.K.  

Journal of the European Ceramic Society, Vol. 24, Iss. 1, 2004-01 ,pp. : 111-117

Elsevier

Access to resources Recommend Favorite

Induced crystallinity during stretch–blow moulding process and its influence on mechanical strength of poly(ethylene terephthalate) bottles

By Chevalier L.   Linhone C.   Regnier G.  

Plastics, Rubber and Composites, Vol. 28, Iss. 8, 1999-08 ,pp. : 393-400

Maney Publishing

Access to resources Recommend Favorite