Investigation into white layer formed on wire electrical discharge machined Ti6Al4V surface

ISSN： 1748-5711

Source： International Journal of Machining and Machinability of Materials, Vol.6, Iss.3-4, 2009-07, pp. : 234-249

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Influence of surface layer on properties of hipped Ti–6Al–4V

By Davidson A. Zhang K. Yuan W. Mei J. Hurley P. Bache M. R. Loretto M. H. Voice W. E. Wu X. H.

Materials Science and Technology, Vol. 22, Iss. 5, 2006-05 ,pp. : 553-560

Maney Publishing

Access to resources Recommend Favorite

Modelling and optimisation of hole drilling electrical discharge micromachining process of Ti-6Al-4V thin sheet

By Porwal Rajesh Kumar

International Journal of Precision Technology, Vol. 3, Iss. 2, 2013-04 ,pp. : 183-205

Inderscience Publishers

Access to resources Recommend Favorite

Investigation on surface grinding of Ti-6Al-4V using minimum quantity lubrication

By Guo Guoqiang

International Journal of Abrasive Technology, Vol. 5, Iss. 3, 2012-12 ,pp. : 187-201

Inderscience Publishers

Access to resources Recommend Favorite

Microstructural Evolution of Metal Matrix Composites Formed by Laser Deposition of Ti-6Al-4V Wire and WC-W₂C Powder

Advanced Engineering Forum, Vol. 2018, Iss. 26, 2018-04 ,pp. : 22-32

Trans Tech Publications

Access to resources Recommend Favorite

Surface engineering to improve tribological performance of Ti–6Al–4V

By Dong H. Bloyce A. Morton P. H. Bell T.

Surface Engineering, Vol. 13, Iss. 5, 1997-01 ,pp. : 402-406

Maney Publishing

Access to resources Recommend Favorite