Use of NC kernel data for surface roughness monitoring in milling operations

By Brecher Christian   Quintana Guillem   Rudolf Thomas   Ciurana Joaquim  

The International Journal of Advanced Manufacturing Technology, Vol. 53, Iss. 9-12, 2011-04 ,pp. : 953-962

Springer Publishing Company

Access to resources Recommend Favorite

The design of a single-chip tool monitoring system for on-line turning operation

By Tseng P.-C.   Teng W.-C.  

The International Journal of Advanced Manufacturing Technology, Vol. 24, Iss. 5-6, 2004-09 ,pp. : 404-414

Springer Publishing Company

Access to resources Recommend Favorite

On-line monitoring of tool wear in turning operation in the presence of tool misalignment

By Shahabi H.   Ratnam M.  

The International Journal of Advanced Manufacturing Technology, Vol. 38, Iss. 7-8, 2008-09 ,pp. : 718-727

Springer Publishing Company

Access to resources Recommend Favorite

Prediction of surface roughness in turning operations by computer vision using neural network trained by differential evolution algorithm

By Yang S.   Natarajan U.   Sekar M.   Palani S.  

The International Journal of Advanced Manufacturing Technology, Vol. 51, Iss. 9-12, 2010-12 ,pp. : 965-971

Springer Publishing Company

Access to resources Recommend Favorite

An experimental investigation on the effect of turning parameters on surface roughness

By Thangavel P.   Selladurai V.  

International Journal of Manufacturing Research, Vol. 3, Iss. 3, 2008-07 ,pp. : 285-300

Inderscience Publishers

Access to resources Recommend Favorite