Cyclic axial behaviour of piles and pile groups in sand

Author： Bolton Malcolm D. Haigh Stuart K.

ISSN： 1208-6010

Source： Canadian Geotechnical Journal, Vol.49, Iss.9, 2012-09, pp. : 1074-1087

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Piled foundations are often subjected to cyclic axial loads. This is particularly true for the piles of offshore structures, which are subjected to rocking motions caused by wind or wave actions, and for those of transport structures, which are subjected to traffic loads. As a result of these cyclic loads, excessive differential or absolute settlements may be induced during the piles’ service life. In the research presented here, centrifuge modelling of single piles and pile groups was conducted to investigate the influence of cyclic axial loads on the performance of piled foundations. The influence of installation method was investigated and it was found that the cyclic response of a pile whose jacked installation was modelled correctly is much stiffer than that of a bored pile. During displacement-controlled axial load cycling, the pile head stiffness reduces with an increasing number of cycles, but at a decreasing rate; during force-controlled axial load cycling, more permanent settlement is accumulated for a bored pile than for a jacked pile. The performance of individual piles in a pile group subjected to cyclic axial loads is similar to that of a single pile, without any evident group effect. Finally, a numerical analysis of axially loaded piles was validated by centrifuge test results. Cyclic stiffness of soil at the base of pre-jacked piles increases dramatically, while at base of jacked piles it remains almost constant.