Study of out-of-roundness (OOR) of holes in ceramics by USD process using Taguchi's methodology

ISSN： 1368-2148

Source： International Journal of Manufacturing Technology and Management, Vol.17, Iss.4, 2009-03, pp. : 426-436

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Analysis of surface roughness and out-of-roundness in the electro-chemical honing of internal cylinders

By Dubey A. Shan H. Jain N.

The International Journal of Advanced Manufacturing Technology, Vol. 38, Iss. 5-6, 2008-08 ,pp. : 491-500

Springer Publishing Company

Access to resources Recommend Favorite

Optimisation of MRR in ultrasonic drilling (USD) based on Taguchi's robust design methodology

By Jadoun R.S. Kumar Pradeep Mishra B.K. Mehta R.C.S.

International Journal of Machining and Machinability of Materials, Vol. 1, Iss. 4, 2007-02 ,pp. : 445-462

Inderscience Publishers

Access to resources Recommend Favorite

Manufacturing process optimisation for tool wear rate in ultrasonic drilling of engineering ceramics using the Taguchi method

By Jadoun R.S. Kumar Pradeep Mishra B.K. Mehta R.C.S.

International Journal of Machining and Machinability of Materials, Vol. 1, Iss. 1, 2006-08 ,pp. : 94-114

Inderscience Publishers

Access to resources Recommend Favorite

A Taguchi approach-based study on effect of process parameters in electro discharge machining using orbital tool movement

By Dave Harshit K. Desai Keyur P. Raval Harit K.

International Journal of Machining and Machinability of Materials, Vol. 13, Iss. 1, 2013-02 ,pp. : 52-66

Inderscience Publishers

Access to resources Recommend Favorite

Analysis of contoured holes produced using STED process

By Jain V. Chavan Aatish Kulkarni Anjali

The International Journal of Advanced Manufacturing Technology, Vol. 44, Iss. 1-2, 2009-09 ,pp. : 133-148

Springer Publishing Company

Access to resources Recommend Favorite