Radial gap measurement and manufacturing error evaluation for small hole machined by micro-EDM

Author： Jia Zhenyuan   Zheng Xinyi   Wang Fuji   Liu Wei  

Publisher： Inderscience Publishers

ISSN： 1368-2148

Source： International Journal of Manufacturing Technology and Management, Vol.22, Iss.2, 2011-02, pp. : 94-106

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Effect of flushing condition on deep hole micro-EDM drilling

By Meena Vijay Kumar   Azad Man Singh   Mitra Souren  

International Journal of Machining and Machinability of Materials, Vol. 12, Iss. 4, 2012-11 ,pp. : 308-320

Inderscience Publishers

Access to resources Recommend Favorite

Feasibility evaluation of EDM hole drilling method for residual stress measurement

By Lee H. T.   Hsu F. C.  

Materials Science and Technology, Vol. 19, Iss. 9, 2003-09 ,pp. : 1261-1265

Maney Publishing

Access to resources Recommend Favorite

A review on various research trends in micro-EDM

By Kadirvel A.  

International Journal of Mechatronics and Manufacturing Systems, Vol. 5, Iss. 5-6, 2012-10 ,pp. : 361-384

Inderscience Publishers

Access to resources Recommend Favorite

A method for microstructures fabrication by using micro-EDM

By Zhang Yong   Wang Zhenlong   Li Zhiyong   Zhao Wansheng  

International Journal of Machining and Machinability of Materials, Vol. 2, Iss. 1, 2007-03 ,pp. : 59-70

Inderscience Publishers

Access to resources Recommend Favorite

Basic study on pulse generator for micro-EDM

By Han Fuzhu   Chen Li   Yu Dingwen   Zhou Xiaoguang  

The International Journal of Advanced Manufacturing Technology, Vol. 33, Iss. 5-6, 2007-06 ,pp. : 474-479

Springer Publishing Company

Access to resources Recommend Favorite