Influence of cutting parameters on cycle time, surface roughness, dimensional error and cutting forces in milling operations on aluminium 6082 sculptured surface geometry

By Quintana G.   Gomez X.   Delgado J.   Ciurana J.  

International Journal of Machining and Machinability of Materials, Vol. 8, Iss. 3-4, 2010-01 ,pp. : 339-355

Inderscience Publishers

Access to resources Recommend Favorite

Modelling cutting force including thrust and tangential damping in peripheral milling process

By Mehdi Kamel   Zghal Ali  

International Journal of Machining and Machinability of Materials, Vol. 12, Iss. 3, 2012-09 ,pp. : 236-251

Inderscience Publishers

Access to resources Recommend Favorite

Cutting force prediction depending on process parameters by response surface methodology in milling

By Sivasakthivel P.S.   Murugan V. Vel   Sudhakaran R.  

International Journal of Machining and Machinability of Materials, Vol. 11, Iss. 2, 2012-03 ,pp. : 137-153

Inderscience Publishers

Access to resources Recommend Favorite

Tool path generation for five-axis sculptured surface machining with a toroidal cutter

By Chen Tao   Li Changping   Wang Haichun  

International Journal of Machining and Machinability of Materials, Vol. 8, Iss. 3-4, 2010-01 ,pp. : 372-383

Inderscience Publishers

Access to resources Recommend Favorite

Accessibility comparison for optimal cutter selection in five-axis finish milling of sculptured surfaces

By Li L.L.   Zhang Y.F.   Nee A.Y.C.   Fuh J.Y.H.   Wong Y.S.   Yeung M.   Gui Z.  

International Journal of Manufacturing Research, Vol. 1, Iss. 2, 2006-11 ,pp. : 176-197

Inderscience Publishers

Access to resources Recommend Favorite