Experimental and theoretical studies of workpiece deformation, stress, and strain during flat rolling

Author： Hartley P.   Sturgess C. E. N.   Liu C.   Rowe G. W.  

Publisher： Maney Publishing

ISSN： 1743-2804

Source： International Materials Reviews, Vol.34, Iss.1, 1989-01, pp. : 19-34

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Experimental investigation of stress-strain conditions in punching zone of flat slabs

By  

MATEC Web of conference, Vol. 117, Iss. issue, 2017-07 ,pp. : 00045-00045

Edp Sciences

Access to resources Recommend Favorite

Experimental and theoretical studies of strength and stress-strain properties of the concrete under conditions of complex stress-strain states with presence of tensile stresses from the effect of a single-shot dynamic load of the general form

By Tsvetkov Konstantin  

MATEC Web of conference, Vol. 86, Iss. issue, 2016-11 ,pp. : 01020-01020

Edp Sciences

Access to resources Recommend Favorite

FE Simulation of the Stress-Strain State during Shear-Compression Testing and Asymmetric Three-Roll Rolling Process

By  

MATEC Web of conference, Vol. 95, Iss. issue, 2017-02 ,pp. : 12009-12009

Edp Sciences

Access to resources Recommend Favorite

Analysis of Residual Stress and Deformation of Rolling Strengthen Crankshaft Fillet

By  

MATEC Web of conference, Vol. 67, Iss. issue, 2016-07 ,pp. : 03014-03014

Edp Sciences

Access to resources Recommend Favorite

Experimental investigations and theoretical studies on Rijke Tube

By Zhu Yongbo   Liu Ku   Chen Mingkun   Tian Jing  

INTER-NOISE and NOISE-CON Congress and Conference Proceedings, Vol. 2001, Iss. 5, 2001-08 ,pp. : 1303-1306

Institute of Noise Control Engineering

Access to resources Recommend Favorite