Optimisation of geometry of 185 × 185 mm square billet mould of Sidenor continuous casting machine

Author： Ridolfi M. R.   Gotti A.   Laraudogoitia J. J.   Santisteban V.  

Publisher： Maney Publishing

ISSN： 1743-2812

Source： Ironmaking & Steelmaking, Vol.31, Iss.5, 2004-10, pp. : 371-375

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Continuous casting mould for square steel billet optimised by solidification shrinkage simulation

By Wang T. M.   Cai S. W.   Xu J.   Du Y. Y.   Zhu J.   Xu J. J.   Li T. J.  

Ironmaking & Steelmaking, Vol. 37, Iss. 5, 2010-07 ,pp. : 341-346

Maney Publishing

Access to resources Recommend Favorite

Design of corners of mould in square billet casting

By Mapelli C.   Semplici S.  

Ironmaking & Steelmaking, Vol. 30, Iss. 6, 2003-12 ,pp. : 503-510

Maney Publishing

Access to resources Recommend Favorite

Influence of electromagnetic stirring on transport phenomena in round billet continuous casting mould and macrostructure of high carbon steel billet

By Yu H Q   Zhu M Y  

Ironmaking & Steelmaking, Vol. 39, Iss. 8, 2012-11 ,pp. : 574-584

Maney Publishing

Access to resources Recommend Favorite

Modelling of steel shrinkage and optimisation of mould taper for high speed continuous casting

By Zhu L.-G.   Kumar R. V.  

Ironmaking & Steelmaking, Vol. 34, Iss. 1, 2007-01 ,pp. : 76-82

Maney Publishing

Access to resources Recommend Favorite

Analysis of variability and non-uniformity of mould heat extraction for round billet continuous casting in plant trials

By Yin H. B.   Yao M.   Wang J. C.   Fang D. C.  

Ironmaking & Steelmaking, Vol. 33, Iss. 4, 2006-08 ,pp. : 299-305

Maney Publishing

Access to resources Recommend Favorite