Optimal configuration of blast furnace slag runner to reduce fluid flow stresses at wall using mathematical modelling

ISSN： 1743-2812

Source： Ironmaking & Steelmaking, Vol.37, Iss.1, 2010-01, pp. : 9-14

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Flow induced stress distribution on wall of blast furnace hearth

By Vats A.K. Dash S.K.

Ironmaking & Steelmaking, Vol. 27, Iss. 2, 2000-04 ,pp. : 123-128

Maney Publishing

Access to resources Recommend Favorite

Numerical modelling of iron flow and heat transfer in blast furnace hearth

By Panjkovic V. Truelove J. S. Zulli P.

Ironmaking & Steelmaking, Vol. 29, Iss. 5, 2002-10 ,pp. : 390-400

Maney Publishing

Access to resources Recommend Favorite

Fluid selection for organic Rankine cycle in waste heat power generation during water quenching of blast furnace slag

By Zhang L H Wu L J Lu Z A

Ironmaking & Steelmaking, Vol. 40, Iss. 2, 2013-02 ,pp. : 147-152

Maney Publishing

Access to resources Recommend Favorite

Experimental simulations of primary slag formation in blast furnace

By Tanskanen P. A. Huttunen S. M. Mannila P. H. Härkki J. J.

Ironmaking & Steelmaking, Vol. 29, Iss. 4, 2002-08 ,pp. : 281-286

Maney Publishing

Access to resources Recommend Favorite

A way to reduce environmental impact of ladle furnace slag

By Branca T. A. Colla V. Valentini R.

Ironmaking & Steelmaking, Vol. 36, Iss. 8, 2009-11 ,pp. : 597-602

Maney Publishing

Access to resources Recommend Favorite