Fabrication and machinability of Si₃N₄–Mg–Al–Zn (AZ91) composites

Author： Wang S. R. Geng H. R. Wang Y. Z.

ISSN： 1743-2847

Source： Materials Science and Technology, Vol.22, Iss.2, 2006-02, pp. : 223-226

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Processing and superplastic properties of fine grained Si₃N₄/Al–Mg–Si composites

By Mabuchi M. Iwasaki H. Higashi K. Langdon T. G.

Materials Science and Technology, Vol. 11, Iss. 12, 1995-12 ,pp. : 1295-1300

Maney Publishing

Access to resources Recommend Favorite

Fabrication, microstructures, and tensile properties of magnesium alloy AZ91/SiC_p composites produced by powder metallurgy

By Lee D. M. Suh B. K. Kim B. G. Lee J. S. Lee C. H.

Materials Science and Technology, Vol. 13, Iss. 7, 1997-07 ,pp. : 590-595

Maney Publishing

Access to resources Recommend Favorite

Fabrication and characterisation of AZ91/SiC composite by pressureless infiltration method

By Yang H R Kwon H Lee K B

Materials Science and Technology, Vol. 27, Iss. 6, 2011-06 ,pp. : 1053-1058

Maney Publishing

Access to resources Recommend Favorite

Rheological behaviour and fluidity of SiC_p+AZ91HP magnesium composites

By Kim S.K. Kim Y.J.

Materials Science and Technology, Vol. 16, Iss. 7-8, 2000-07 ,pp. : 877-881

Maney Publishing

Access to resources Recommend Favorite

Cavitation and fracture in high strain rate superplastic Al alloy/Si₃N_4(p) composites

By Iwasaki H. Mabuchi M. Higashi K.

Materials Science and Technology, Vol. 12, Iss. 6, 1996-06 ,pp. : 505-512

Maney Publishing

Access to resources Recommend Favorite