Surface engineering of Ti–6Al–4V by nitriding and powder alloying using CW CO₂ laser

ISSN： 1743-2847

Source： Materials Science and Technology, Vol.24, Iss.2, 2008-02, pp. : 189-200

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Formation of surface layers on Ti–6Al–4V titanium alloy by laser alloying

By Filip R. Sieniawski J. Pleszakov E.

Surface Engineering, Vol. 22, Iss. 1, 2006-02 ,pp. : 53-57

Maney Publishing

Access to resources Recommend Favorite

Hard coatings by laser gas alloying of Ti6Al4V

By Damborenea J. De Fernandez B. Lopez V. Vazquez A.J.

International Journal of Materials and Product Technology, Vol. 11, Iss. 3-4, 1996-11 ,pp. : 301-309

Inderscience Publishers

Access to resources Recommend Favorite

Composite layer formation on Ti–6Al–4V surfaces by laser treatment using prepiaced SiC powder

By Mridha S. Baker T. N.

Surface Engineering, Vol. 13, Iss. 3, 1997-01 ,pp. : 233-237

Maney Publishing

Access to resources Recommend Favorite

Laser gas assisted nitriding of Ti–6Al–4V alloy and residual stress analysis

By Yilbas B. S. Arif A. F. M. Karatas C.

Surface Engineering, Vol. 25, Iss. 3, 2009-04 ,pp. : 228-234

Maney Publishing

Access to resources Recommend Favorite

Surface engineering to improve tribological performance of Ti–6Al–4V

By Dong H. Bloyce A. Morton P. H. Bell T.

Surface Engineering, Vol. 13, Iss. 5, 1997-01 ,pp. : 402-406

Maney Publishing

Access to resources Recommend Favorite