

Author: Henriksen B. R. Johnsen T. E.
Publisher: Maney Publishing
ISSN: 1743-2847
Source: Materials Science and Technology, Vol.6, Iss.9, 1990-09, pp. : 857-862
Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.
Abstract
The relationship between microstructure and mechanical properties of composites of squeeze cast Al–Cu and Al–Cu–Mg reinforced with 25 vol.-%SiC whiskers was investigated. Tensile test results were compared with values calculated using a modified rule of mixtures (ROM). The results were found to be in good agreement for the Al–Cu matrix composite, whereas a relatively large discrepancy was observed for the Al–Cu–Mg matrix composite. It was concluded from microstructural observations that this difference resulted from a reduction of the whisker strength due to more pronounced decoration of the interfaces by oxides and spinels. For the Al–Cu–Mg composite, the effect of interfacial phases on the composite strength must betaken into account when the modified ROM is applied.MST/1242
Related content


By Shamsul J. B. Hammond C. Cochrane R. F. Shakesheff A. J.
Materials Science and Technology, Vol. 14, Iss. 9-10, 1998-09 ,pp. :





