Effect of processing conditions on shrinkage and warpage and morphology of injection moulded parts using microcellular injection moulding

By Kramschuster A.   Cavitt R.   Ermer D.   Chen Z. B.   Turng L.-S.  

Plastics, Rubber and Composites, Vol. 35, Iss. 5, 2006-06 ,pp. : 198-209

Maney Publishing

Access to resources Recommend Favorite

Immiscibility of Silicone Rubber and Polymethylmethacrylate

By Vijayalakshmi N.  

International Journal of Polymeric Materials, Vol. 57, Iss. 7, 2008-07 ,pp. : 709-716

Taylor & Francis Ltd

Access to resources Recommend Favorite

Cavity Pressure Response and Melt Flow Length During Dynamic Injection Molding

By Hong-wu Wu   hai-hang Xu   Jin-ping Qu   Shao-dan Zhang  

Polymer-Plastics Technology and Engineering, Vol. 45, Iss. 8, 2006-01 ,pp. : 935-937

Taylor & Francis Ltd

Access to resources Recommend Favorite

Measurement and Analysis of Cavity Pressure and Melt Filling Capacity During Injection Molding

By Hong-wu Wu   Shao-dan Zhang   Jin-ping Qu   Hai-hang Xu  

Polymer-Plastics Technology and Engineering, Vol. 46, Iss. 2, 2007-02 ,pp. : 123-127

Taylor & Francis Ltd

Access to resources Recommend Favorite

Fibre orientation structures and their effect on crack resistance of injection moulded transverse ribbed plate

By Hine P.J.   Duckett R.A.   Caton-Rose P.   Coates P.D.  

Plastics, Rubber and Composites, Vol. 33, Iss. 1, 2004-01 ,pp. : 43-53

Maney Publishing

Access to resources Recommend Favorite