Effect of processing conditions on shrinkage and warpage and morphology of injection moulded parts using microcellular injection moulding

By Kramschuster A.   Cavitt R.   Ermer D.   Chen Z. B.   Turng L.-S.  

Plastics, Rubber and Composites, Vol. 35, Iss. 5, 2006-06 ,pp. : 198-209

Maney Publishing

Access to resources Recommend Favorite

Thermal degradation studies of cyclic olefin copolymers

By Liu C.   Yu J.   Sun X.   Zhang J.   He J.  

Polymer Degradation and Stability, Vol. 81, Iss. 2, 2003-01 ,pp. : 197-205

Elsevier

Access to resources Recommend Favorite

Evaluation of replication properties on moulded surface by ultrasonic injection moulding system

By Sato A.   Sakaguchi H.   Ito H.   Koyama K.  

Plastics, Rubber and Composites, Vol. 39, Iss. 7, 2010-09 ,pp. : 315-320

Maney Publishing

Access to resources Recommend Favorite

Effects of Processing Parameters on Tensile Strength of Thin-Wall HDPE Parts Injection Molded by Ultra High-Speed Process

By Chen Shia-Chung   Li Hai-Mei  

Polymer-Plastics Technology and Engineering, Vol. 50, Iss. 3, 2011-01 ,pp. : 276-281

Taylor & Francis Ltd

Access to resources Recommend Favorite

Does fountain flow influence molecular orientation in injection moulded parts?

By Nguyen-Chung T.   Mennig G.  

Plastics, Rubber and Composites, Vol. 35, Iss. 10, 2006-12 ,pp. : 418-424

Maney Publishing

Access to resources Recommend Favorite