Interpretation of results of full notch creep test and comparison with notched pipe test

ISSN： 1743-2898

Source： Plastics, Rubber and Composites, Vol.34, Iss.7, 2005-09, pp. : 294-300

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Comparison of test configurations for determination of mode II interlaminar fracture toughness results from international collaborative test programme

By Davies P. Sims G.D. Blackman B.R.K. Brunner A.J. Kageyama K. Hojo M. Tanaka K. Murri G. Rousseau C. Gieseke B. Martin R.H.

Plastics, Rubber and Composites, Vol. 28, Iss. 9, 1999-09 ,pp. : 432-437

Maney Publishing

Access to resources Recommend Favorite

On the comparison between a detailed turbine-generator EMTP simulation and corresponding field test results

By Khodabakhchian B.

Fuel and Energy Abstracts, Vol. 38, Iss. 4, 1997-07 ,pp. : 254-255

Elsevier

Access to resources Recommend Favorite

Development of notched ring test for measuring slow cracking resistance in plastics pipes and fittings

By Choi S. Pyo S. Suh Y. S. Seo Y.

Plastics, Rubber and Composites, Vol. 36, Iss. 5, 2007-06 ,pp. : 219-225

Maney Publishing

Access to resources Recommend Favorite

Mode II fracture toughness evaluation using four point bend, end notched flexure test

By Martin R.H. Davidson B.D.

Plastics, Rubber and Composites, Vol. 28, Iss. 8, 1999-08 ,pp. : 401-406

Maney Publishing

Access to resources Recommend Favorite

Loadless full load temperature rise test for three phase induction motors

Fuel and Energy Abstracts, Vol. 43, Iss. 2, 2002-03 ,pp. : 132-132

Elsevier

Access to resources Recommend Favorite