Surface gloss difference on water assisted injection moulded thermoplastic parts: effects of processing variables

Author： Liu S.-J.   Wu Y.-C.   Chen W.-K.  

Publisher： Maney Publishing

ISSN： 1743-2898

Source： Plastics, Rubber and Composites, Vol.35, Iss.1, 2006-02, pp. : 29-36

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Core out geometries in water channels of water assisted injection moulded parts

By Wu Y.-C.   Chen K.-M.   Liu S.-J.  

Plastics, Rubber and Composites, Vol. 35, Iss. 10, 2006-12 ,pp. : 425-431

Maney Publishing

Access to resources Recommend Favorite

Investigations into surface visual quality of gas-assisted injection moulded polypropylene parts

By Der Chien Rean   Chen Shia-Chung  

Plastics, Rubber and Composites, Vol. 33, Iss. 4, 2004-05 ,pp. : 155-162

Maney Publishing

Access to resources Recommend Favorite

Effects of processing parameters on formation of sinkmarks on injection moulded parts

By Liu S-J.  

Plastics, Rubber and Composites, Vol. 30, Iss. 4, 2001-04 ,pp. : 170-174

Maney Publishing

Access to resources Recommend Favorite

Experimental investigation and numerical simulation of cooling process in water assisted injection moulded parts

By Liu S.-J.   Chen W.-K.  

Plastics, Rubber and Composites, Vol. 33, Iss. 6, 2004-08 ,pp. : 260-266

Maney Publishing

Access to resources Recommend Favorite

Study of mouldability in gas-assisted injection moulded fibre-reinforced Nylon parts

By Chen S.-C.   Chien R.D.   Chen Y.-C.   Teng M.-Y.  

Plastics, Rubber and Composites, Vol. 33, Iss. 2-3, 2004-03 ,pp. : 113-119

Maney Publishing

Access to resources Recommend Favorite