Mechanical Properties of Duplex Fe—Ni—C Alloys Prepared by Powder Metallurgy Techniques

ISSN： 1743-2901

Source： Powder Metallurgy, Vol.23, Iss.2, 1980-01, pp. : 65-70

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Homogenization in Sintering and Its Influence on Mechanical Properties of Fe–Cr–C and Fe–Ni–C Steels

By Vityaz P. A. Nasybulin A. Kh.

Powder Metallurgy, Vol. 28, Iss. 3, 1985-01 ,pp. : 166-168

Maney Publishing

Access to resources Recommend Favorite

Characterisation of samples from Fe based composite materials prepared by different powder metallurgy techniques

By Lu Z. L. Shi Y. S. Liu J. H. Chen Y. Huang S. H.

Powder Metallurgy, Vol. 51, Iss. 3, 2008-09 ,pp. : 257-262

Maney Publishing

Access to resources Recommend Favorite

Effect of Phase Distribution on Mechanical Properties of Fe—Ni Heterogeneous Alloys

By Nakamura M. Tsuya K.

Powder Metallurgy, Vol. 22, Iss. 4, 1979-01 ,pp. : 179-186

Maney Publishing

Access to resources Recommend Favorite

Effect of Heat Treatment on Structure and Mechanical Properties of Sintered Fe–Ni Alloys

By Nakamura M. Tsuya K.

Powder Metallurgy, Vol. 26, Iss. 3, 1983-01 ,pp. : 149-154

Maney Publishing

Access to resources Recommend Favorite

Enhanced Mechanical Properties of Ti(C,B)-Based Cermets with Multi-Component AlCoCrFeNi High-Entropy Alloys Binder

Key Engineering Materials, Vol. 2017, Iss. 727, 2017-03 ,pp. : 149-153

Trans Tech Publications

Access to resources Recommend Favorite