Influence of Process Parameters on Precision of PM Parts

ISSN： 1743-2901

Source： Powder Metallurgy, Vol.28, Iss.3, 1985-01, pp. : 155-165

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Influence on Precision of PM Parts of Various Binder Additions to Powder

By Tengzelius J. Engström U.

Powder Metallurgy, Vol. 28, Iss. 1, 1985-01 ,pp. : 43-48

Maney Publishing

Access to resources Recommend Favorite

Influence of Process Parameters on Geometric Precision of Machined Surface after WEDM

Key Engineering Materials, Vol. 2017, Iss. 756, 2017-10 ,pp. : 107-118

Trans Tech Publications

Access to resources Recommend Favorite

The Influence of Process Parameters on Microstructure and Mechanical Properties of PM Al+4 wt. %Cu Alloy

Key Engineering Materials, Vol. 2016, Iss. 682, 2016-03 ,pp. : 252-258

Trans Tech Publications

Access to resources Recommend Favorite

Influence of feedstock characteristics and process parameters on properties of MIM parts made of 316L

By Berginc B. Kampus Z. Sustarsic B.

Powder Metallurgy, Vol. 50, Iss. 2, 2007-06 ,pp. : 172-183

Maney Publishing

Access to resources Recommend Favorite

Sintering Procedures for Aluminium P/M Parts and Metallographic Examination During the Process

By Amato I. Corso S. Sgambetterra E.

Powder Metallurgy, Vol. 19, Iss. 3, 1976-01 ,pp. : 171-175

Maney Publishing

Access to resources Recommend Favorite